Digital Input Input Channel 4
Input Type Isolated differential digital input
ON State Input voltage > 3.5V
OFF State Input voltage < 1V
Input Impedance 3K Ohms
Isolation Voltage 5000 Vrms
Relay Output Output Channel 4
Contact Type Form C : changeover contact
Contact Rating 0.6A@125VAC or 2A@30VDC
Operate/Release Time 3mS/2mS max.
Operation Life Mechanical : 108 min.
Electrical : 5*105 min. (2A@30VDC)
Dielectric Strength between open contacts : 500VRMS
between contacts and coil : 1000VRMS
LED Display 1 LED as Power/Communication indicator
4 LEDs as digital input indicators
4 LEDs as relay output indicators
Power Consumption Maximum : 1.0W


i-87063 pin assignment
Terminal Number Pin Name
1DI0+
2DI0-
3DI1+
4DI1-
5DI2+
6DI2-
7DI3+
8DI3-
9NO0
10NC0
11COM0
12NO1
13NC1
14COM1
15NO2
16NC2
17COM2
18NO3
19NC3
20COM3


i-87063 block diagram


Input Type ON State
LED ON
Readback as 1		 OFF State
LED OFF
Readback as 0
Relay Contact
relay close i-87063 digital input
relay open i-87063 digital input
TTL/CMOS Logic
logic low i-87063 digital input
logic high i-87063 digital input
Open Collector
open collector on i-87063 digital input
open collector off i-87063 digital input

Output Type ON State
LED ON
Readback as 1		 OFF State
LED OFF
Readback as 0
Relay Contact
load current on i-87063 relay contact
load current off i-87063 relay contact


i-87063 dimention


Configuration Default Setting Description
Type 40 Digital Input/Output
Baudrate 0A 115200 bps
Format 00 CheckSum disable


Command Description
%AANNTTCCFF Set Module Configuration
$AA2 Read configuration
$AA4 Read synchronized digital input/output status
$AA5 Read reset status
$AA6 Read digital input/output status
$AAC Clar latched digital inputs
$AACN Clar digital input counter from specificed channel
$AAF Read firmware version
$AALS Read latched digital inputs
$AAM Read module name
#** Synchronized sampling
#AABBDD Digital output
#AAN Read digital input counter from specificed channel
@AA Read digital input/output status
@AA(Data) Set digital outputs
~AA0 Read module status
~AA1 Reset module status
~AA2 Read host watchdog timeout setting
~AA3ETT Set host watchdog timeout setting
~AA4S Read PowerOn Value / Safe Value
~AA5S Set PowerOn Value / Safe Value
~AAO(Name) Set module name


Back to Previous Page