I-87013 Specification

Analog Input	Input Channel	4 RTD Input Channels
	Input Type	2-Wire, 3-Wire or 4-Wire RTD
	Sampling Rate	10 samples/second total
	-3dB BandWidth	15.7Hz
	Accuracy	+/-0.1%
	Common Mode Rejection	150dB @50/60Hz
	Normal Mode Rejection	100dB @50/60Hz
	Isolation Voltage	3000Vrms
LED Display	1 LED as Power/Communication indicator 8 LEDs as High/Low Alarm signals
Power Consumption	Maximum : 0.7W

I-87013 Pin Assignment

i-87013 pin assignment

Terminal Number	Pin Name
1	Iexc0+
2	Sense0+
3	Sense0-
4	Iexc0-
5	AGND
6	Iexc1+
7	Sense1+
8	Sense1-
9	Iexc1-
10	AGND
11	Iexc2+
12	Sense2+
13	Sense2-
14	Iexc2-
15	AGND
16	Iexc3+
17	Sense3+
18	Sense3-
19	Iexc3-
20	AGND

I-87013 Block Diagram

i-87013 block diagram

I-87013 Wire Connection

2-Wire RTD Connection
3-Wire RTD Connection
4-Wire RTD Connection
Screw wire into I-87013

I-87013 Dimention

i-87013 dimention

I-87013 Default Setting

Configuration	Default Setting	Description
Type	20	PT100, a=0.00385, -100 to 100 degree Celsius
Baudrate	0A	115200 bps
Format	00	60Hz rejection CheckSum disable Engineer Unit Format

I-87013 Command Sets

Command	Description
%AANNTTCCFF	Set Module Configuration
$AA0	Span calibration
$AA1	Offset calibration
$AA2	Read configuration
$AA5VV	Set channel enable/disable status
$AA6	Read channel enable/disable status
$AAF	Read firmware version
$AAM	Read module name
#AA	Read analog inputs of all channels
#AAN	Read analog input of specificed channel
@AACS	Clear maximum/minimum analog inputs
@AACSN	Clear maximum/minimum analog input of specificed channel
@AARS	Read maximum/minimum analog inputs
@AARSN	Read maximum/minimum analog input of specificed channel
~AA0	Read module status
~AA1	Reset module status
~AA2	Read host watchdog timeout setting
~AA3ETT	Set host watchdog timeout setting
~AAO(Name)	Set module name

Back to Previous Page