I-87017 Specification

Analog Input	Input Channel	8 differential input channels
	Input Type	mV, V mA(with external 125 Ohms resistor)
	Sampling Rate	10 samples/second total
	-3dB BandWidth	15.7Hz
	Accuracy	+/-0.1%
	Common Mode Rejection	86dB
	Voltage Input Impedance	20M Ohms
	Overvoltage Protection	-35V to +35V maximum
	Isolation Voltage	3000Vrms
LED Display	1 LED as Power/Communication indicator 16 LEDs as High/Low Alarm signals
Power Consumption	Maximum : 1.8W

I-87017 Pin Assignment

Terminal Number Pin Name 5 Vin0+ 6 Vin0- 7 Vin1+ 8 Vin1- 9 Vin2+ 10 Vin2- 11 Vin3+ 12 Vin3- 13 Vin4+ 14 Vin4- 15 Vin5+ 16 Vin5- 17 Vin6+ 18 Vin6- 19 Vin7+ 20 Vin7-

I-87017 Block Diagram

I-87017 Wire Connection

Voltage Input Wiring
Current Input Wiring
Screw wire into I-87017

I-87017 Dimention

I-87017 Default Setting

Configuration	Default Setting	Description
Type	08	-10V to +10V
Baudrate	0A	115200 bps
Format	00	60Hz rejection CheckSum disable Engineer Unit Format

I-87017 Command Sets

Command	Description
%AANNTTCCFF	Set Module Configuration
$AA0	Span calibration
$AA1	Offset calibration
$AA2	Read configuration
$AA5VV	Set channel enable/disable status
$AA6	Read channel enable/disable status
$AAF	Read firmware version
$AAM	Read module name
#AA	Read analog inputs of all channels
#AAN	Read analog input of specificed channel
@AACS	Clear maximum/minimum analog inputs
@AACSN	Clear maximum/minimum analog input of specificed channel
@AARS	Read maximum/minimum analog inputs
@AARSN	Read maximum/minimum analog input of specificed channel
~AA0	Read module status
~AA1	Reset module status
~AA2	Read host watchdog timeout setting
~AA3ETT	Set host watchdog timeout setting
~AAO(Name)	Set module name

Back to Previous Page